I've sprayed parts black to help me find holes and high / low points. Below is how it currently looks
The next two bits to do are;
* Make a dial surround that also fits over the key hole.
* Fix new demist vents on top of dashboard.
I'm taking a new approach to the demister to lower the amount of piping. I will bond the below under the dashboard where the the vent holes are.
I will then get both outlets to join under the dashboard and then go into this channel which will then feed out of two vents. The piece about is 660mm long so will fit fully across the dashboard.
After the above 2 pieces are done. I will look into starting the flocking.
